SPECIFICATION OF PRODUCT
SPECIFICATION OF PRODUCT
APPLICATION SURFACES
COVERED AREA
DURABILITY
SHELF LIFE
THERMAL RESISTANCE
CHEMICAL RESISTANCE
WATER CONTACT ANGLE
APPLICATION TEMPERATURE
CURING PERIOD
STORAGE CONDITIONS
PACKAGING
OUR VIDEOS
OUR VIDEOS
PREPARATION OF SURFACE
Adequately prepare the surface before application of Hendlex APL4. Guidelines to follow to ensure the effectiveness of the product:
- The surface must be washed thoroughly, free of any grease, contaminants, and residue.
- Prior coatings or waxes should be removed. Hendlex Wax Remover is recommended.
- Highly recommended to polish the surface to remove any scratches, swirls, or holograms.
- Ensure the surface is completely dry.
Note: it is recommended to use Hendlex Paint Prepare before applying coating for best results.
USAGE
1. Handle the applicator by the base. Place the application cloth on the soft part of the applicator, tightening it into cutouts on both sides.
*For smaller areas it is recommended to solely use the application cloth without using the applicator.
2. Open the bottle and wet the application cloth entirely. Throughout the process of coating, keep the application cloth wet by applying additional 5-6 drops.
3. Coat the surface evenly in criss-cross motion. Do not use circular movements for product coating. Coat one panel at the time. Try to coat from edge to edge to avoid coating layering marks. Make sure there are no uncovered spots left.
4. After applying coating, wait for:
– if temperature is lower than +24 °C – 3-4 minutes;
– if temperature is higher than +24 °C – 1-2 minutes;
– do not coat if temperature is more than +30 °C.
5. Polish the surface with the high quality microfiber cloth. Make sure there are no unpolished spots left.
6. Recommended coating curing period:
– if the temperature is higher than +22°C – 12 hours initial;
– if the temperature is +20°C – 24 hours initial.
Do not wash the airplane for at least 7 days. Depending on the environment temperature, the coating fully hardens in 7 days.
CAUTION!
Do not apply the coating on matte surfaces or direct sunlight.
Proper application temperature range: +10 °C to +25 °C.
Do not coat if temperature is more than +30 °C.
Upon finishing applying the coating, polish it by using microfiber cloth.
Ensure there are no spots left unpolished.
Adhesive tape does not stick on the coated surface. Do not coat Hendlex APL4 ceramic coating on the surface where adhesive tape will be applied.
Find more products for the aviation here / If you have any questions about the product, please contact us
Ceramic Coat APL4 is the long-lasting nano-coating for airplanes’ bodies. Usually, the slipperiness of the airplane surface is covered with a coating that lasts shortly (maximum for a few months). However, this protective ceramic coating lasts 2 to 5 years, depending on the conditions of use.
Nano-coating for airplanes provides strong resistance from wind, raindrops, and slipperiness, and it helps to develop faster speed for the aircraft. Ceramic Coating APL4 offers less air friction, water repellency, easier grease removal, and shine. This coating for aviation is safe to use and has no side effects for the airplane.
PACKED UNDER INERT GAS. Guaranteed 100% effectiveness.
EN
LT
